Filter
Top Products
SECTION 1 WATER SOFTENER START UP
C. PROGRAM THE TIMER
display UP button
\ \L;W
[ ] ALT
Customer Assistance
1-800-428-9345
TONIGHT
HOLD FOR
_,, IMMEDIATE ,,j
RECHARGE button SELECT button DOWN button
When the transformer is plugged in, a model code,
and a test number (example: J1.0) show in the face
plate display for 4 seconds. Then, the words SET
TIME show in the display along with a flashing
12:00 PM.
¢OOEI
SP2SI
UltraSoft 175
LtJ
Notes:
If ..... shows in the display, press the UP [_ or
DOWN [_ button until SR25 or SR26 shows. Then,
press the SELECT button to set, and change to the
flashing SET TIME display.
To check the model code, unplug the transformer at
the wall outlet and plug in again, if other than SR25
or SR26 shows, see page 5-3 to reset.
SOUND "BEEPER": A "beeper" sounds while
pressing buttons for timer set-up. One beep signals
a change in the face plate display. Repeated beeps
mean the timer will not accept a change from the
button you have pressed, telling you to use another
button. For example, while setting the hardness
(step 2), the beeper sounds repeatedly when the dis-
play reaches 1 using the DOWNbutton, or the high-
est hardness setting using the UP button.
SET PRESENT TIME OF DAY
If the words SET TIME do not show in the display,
press the SELECT button (FIG. 2) until they do, or
see the previous notes.
• Press the UP / DOWN buttons to set the present
time. Press UP to move the display ahead; press
DOWN to SET the time back.
If the present time is between ,[SEr ]
noon and midnight, be sure PM ITM
I
shows. I 14:SB ..
If the present time is between [SEt
midnight and noon, be sure AM [_'MEshows.
Each press of the UP /DOWN buttons changes
the time by one minute. Holding the buttons in
changes the time rapidly.
1-3
Problems, Questions? Call 1- 800- 426- 9345 Kenmore Water Line