Filter
Top Products
SECTION1 WATER SOFTENER START UP
C. PROGRAM THE TIMER
display/I-
RECHARGE button
f
f_
_,._;TRONf_ BeQhaFge Tonight
WATER
_,__ up button
SOFTENER
down button
SELECT button
When the transformer is plugged in, a model code,
and a test number (example: $3.0) show in the face
plate display for 4 seconds. Then, 12:00 AM and
PRESENT TIME begin to flash.
53.0
=RESENT TIMtE j
Notes:
If SR - - shows in the display, press the UP [Zg or
DOWN (_ button until SR17 is shown. Then, press
the SELECT button to set, and change to the flashing
PRESENT TIME display.
To check the model code, unplug the transformer at
the wall outlet and plug in again, if other than SR17
shows, see page 5-3 to reset.
SOUND "BEEPER": A "beeper" sounds while
pressing buttons for timer set-up. One beep signals
a change in the face plate display. Repeated beeps
mean the timer will not accept a change from the
button you have pressed, telling you to use another
button. For example, while setting the hardness
(step 2), the beeper sounds repeatedly when the dis-
play reaches i using the DOWN button, or the high-
est hardness setting using the UP button.
_SET PRESENT TIME OF DAY
If the words PRESENT TIME do not show in the dis-
play, press the SELECTbutton (FIG. 2) until they do,
or see the previous notes.
• Press the UP / DOWN buttons to set the present
time. Press UP to move the display ahead; press
DOWN to move the time backward.
If the present time is between
noon and midnight, be sure PM
shows.
If the present time is between
midnight and noon, be sure AM
shows.
Each press of the UP /DOWN buttons changes
the time by one minute. Holding the buttons in
changes the time rapidly.
1-3
Problems, Questions? Call 1-800-426-9345 Kenmore Water Line