Filter
Top Products
SECTION4 KNOW ABOUT YOUR WATER SOFTENER
A. DIMENSIONS / SPECIFICATIONS
S
C
N
i_J_J_ _J_J_ _J_.
i_J_ _J_J_ _J_.
F
A
B
C
D
E
F1
F2
GM
Salt Tank Height 34-1/2 102.2
Resin Tank Diameter 8 20.3
(nominal)
Resin Tank Height 35 101.6
(nominal)
Inlet-Outlet Height 36-1/2 105.4
Overall Height 46 116.8
Length 18 49.5
Width 11-1/2 41,9
Distance between inlet- 3-3/8 8.6
outlet center lines
BYPASS VALVES
Bypass valve(s) should always remain in soft
water service position, Position in "bypass" only
if needed for softener repairs.
IN OUT SINGLE BYPASS
PULL STEM
OUTWARD
FOR
SERVICE
3 - VALVE BYPASS
FOR SERVICE
close bypass valve
open inlet & outlet valves
FOR BYPASS
open bypass valve
close inlet & outlet valves
OUT
Outlet
Valve
IN
Bypass
1_ Valve
Inlet
Va_e
KENMORE 0-20 TIMER SR CODE SR17
Note: Please see the rating decal for operating capacity, salt usage and service flow rate/pressure loss
performance specifications. Performance specifications NSF/ANSI 44 standard requirements. The rating
decal is located on the rim, under the salt hole cover (see page A, inside front cover).
WATER SUPPLY TO WATER SOFTENER
Minimum water system flow (gpm)
Minimum-Max. water pressure (psi).
Minimum-Max. water temperature (°F)
Maximum water hardness (gpg)
Maximum "clear water" iron (ppm)
3
20 - 125
40- 120
41
5
SALT FOR WATER SOFTENER
Type of salt needed
Alternate type of salt
nugget or pellet
pure, evaporated, compacted
water softener salt
4-1
Problems, Questions? Call 1-800-426-9345 Kenmore Water Line