Kenmore 625.38556 Water System User Manual


 
INSTALLREVERSEOSMOSISFILTERASSEMBLY
The Reverse Osmosis Filter Assembly can sit upright or lay
on its side. When planning your installation, you need to
allow adequate tubing lengths to be able to access the
back of the Reverse Osmosis assembly in order to change
the monitor battery. See Figure 11.
Figure 11
INSTALL STORAGE TANK
1. Apply thread sealing tape to the threads on the nipple
at the top of the tank (max. 2 wraps). See Figure 12.
2. Locate the tubing connector. Tighten the tubing connec-
tor with a wrench onto the tank nipple 7-8 turns, being
careful not to cross thread or overtighten. See Figure 12
3. Do not connect the tube at this time. This will occur
later in the assembly.
4. Place the storage tank next to the Reverse Osmosis
Assembly. The tank can be placed upright or on its
side.
Jr
Jj
//
/ /
//
tank nipple _/tubing connector
ge tank
Figure 12
Questions? Call The Kenmore Water Line 1-800-426-9345 or visit KenmoreWater.com
11