Filter
Top Products
[
A
BYPASS VALVES
Bypass valve(s) should always remain in soft water
service position. Position in "bypass" only if needed for
softener repairs.
SINGLE BYPASS
pull stem
outward for
service
push
inward for
bypass
Inches cm
A iSalt Tank Height 40-1/4 102.2
B Resin Tank Diameter 9 22.9
(nominal)
C Resin Tank Height (nominal) 40 101.6
D Inlet-Outlet Height 41-1/2 105.4
E Overall Height 47-3/4 121.3
F1 Length 19-3/4 50.2
F2 Width 16-1/2 41.9
- Distance between inlet-outlet 3-3/4 8.6
centerlines
3 VALVE BYPASS Bypass
FOR SERVICE valve
close bypass valve
open inlet & outlet valves
FOR BYPASS Outlet
open bypass valve Inlet
close inlet & outlet valve
MODEL NO. 625.383760 - TIMER CODE H 32
FIG. 57
WATER SUPPLY TO WATER SOFTENER
Minimum water system flow (gpm) 3
Minimum-maximum water pressure (psi) 20 - 125
Minimum-maximum water temperature (°F) 40 - 120
Maximum water hardness (gpg) 110
Maximum "clear water" iron (ppm)* 10
SALT FOR WATER SOFTENER
Type of salt needed nugget
Alternate type of salt pure, evaporated, compacted
water softener salt
gpm = gallons per minute gpg = grains per gallon
psi = pounds per square inch ppm = parts per million
* Capacity to remove clear water iron is substantiated by WQA test data. State of Wisconsin requires
additional treatment if water supply contains greater than 5 ppm clear water iron.
Questions? Call The Kenmore Water Line 1-800-426-9345
33