Filter
Top Products
INSTALLCOVERS
Afterinstallingyourwatersoftener,replacethecovers.Angle
thecoverssothemaincoverclipsontothebackfirst,then
bringdowninfrontandcliponthetwo(2)tabsinsidetherim
ofthesaltholeandlowerthesaltcoverclosed.SeeFig.23.
RESTART THE WATER HEATER
Turn on the gas (or electric) supply to the water heater and
light the pilot.
YOUR PLUMBING INSTALLATION AND ELECTRICAL
WORK ARE NOW COMPLETE.
Cover
(Main)
Salt Hole
Cover
FiG. 23
REGENERATION Button
Salt Level Adjust Display
UP Button
Signal Light
Adjust
-- DOWN Button
Tank Light SELECT Buttons
PROGRAM THE TIMER
1. When the transformer is plugged in, a model code
(H 32), and a test number (example: J1.1) show in the
face plate display for 4 seconds. Then, 12:00 AM and f_:'_':_ H _qi2_-I-i
PRESENT TIME begin to flash.
1
NOTE: If '" - - -" shows in the display, press the UP
or DOWN button until H 32 shows in the display. _ I I I
Then, press the SELECT button to set, and change j_ _ J I. I
to the flashing PRESENT TIME display.
2. To check the model code, unplug the transformer at the
wall outlet and plug in again. If other than H 32 shows,
refer to the Troubleshooting Section.
SOUND "BEEPER": A "beeper" sounds while pressing
buttons for timer setup. One beep signals a change in
the face plate display. Repeated beeps mean the timer
will not accept a change from the button you have
pressed, telling you to use another button. For example,
while setting the hardness the beeper sounds repeated-
ly when the display reaches 1 using the DOWN button,
or the highest hardness setting using the UP button.
FIG. 24
:_i :_P I q,lqlq AM
- -8-- JF,UU
PRESENT TIME
FIG. 25
Questions? Call The Kenmore Water Line 1-800-426-9345
17