Filter
Top Products
WATER SOFTENER START-UP
SECTION 1
6
1C. PROGRAM THE TIMER
FIG. 1
When the transformer is plugged in, the model
code SC21 shows in the face plate display for a few
seconds, followed by a test number (example:
S4.0). After the test number, 12:00 AM begins to
flash. PRESENT TIME and RECHARGE TONIGHT
show at the bottom of the display.
NOTE:
If SC - - flashes in the display, press the UP
button (FIG. 1) until SC21 does show. Then press
the SELECT button to display the flashing 12:00
AM. If other than SC21 shows, when the
transformer is plugged in, please see page 17 to
reset.
SOUND BEEPER": A beeper" sounds while
pressing buttons for timer setĆup. One beep
signals a change in the face plate display.
Repeated beeps means the timer will not accept a
change from the button you have pressed, telling
you to use another button. For example, while
setting the hardness (step 2), the beeper sounds
repeatedly when the display reaches 1 using the
DOWN button, or the highest hardness setting
using the UP button.
1. SET PRESENT TIME OF DAY:
NOTE:
If the words…PRESENT TIME do not show in
the display, press the SELECT button (FIG. 1)
until they do.
■ Press the UP/DOWN buttons to set the
present time. Press UP to move the display ahead;
press DOWN to move the time backward.
If the present time is between
noon and midnight, be sure PM
shows.
If the present time is between
midnight and noon, be sure AM
shows.
NOTE:
Each press of the UP/DOWN buttons changes the
time by 1 minute. Holding the buttons in changes
the time 32 minutes each second.