Filter
Top Products
HOW YOUR WATER SOFTENER WORKS
SECTION 2
10
2A. FACE PLATE TIMER FEATURES
EXTRA RECHARGE
Sometimes, a manually started regeneration (reĆ
charge) may be desired, or needed. Two examĆ
ples are:
-- You have used more water than usual (guests
visiting) and you may run out of soft water before
the next timer started regeneration.
-- You did not refill the softener with salt before it
was gone.
You can start a regeneration right away, or you can
set the timer to regenerate at the next 2:00 AM (or
other preset recharge time). Do the following.
RECHARGE NOW
J Press the ON/OFF–HOLD button and
hold
for 3 seconds.
The softener enters the fill
cycle of regeneration right away. . .the display
shows ‘‘FillinG NOW’’. This
regeneration will last for
about 40 minutes. Then, you
will have soft water again.
RECHARGE TONIGHT
■ Press and release (DO NOT HOLD) the
ON/OFF-HOLD button. RE-
CHARGE TONIGHT flashes
in the display, and the soften-
er begins regeneration at the
next preset recharge time. Press and release
the ON/OFF-HOLD button once more if you
decide to cancel the regeneration, and RE-
CHARGE TONIGHT.
PROGRAM MEMORY
If electrical power to the softener goes off, the
time display is blank but the face plate timer keeps
the correct time for about 6 hours. When electrical
power comes on again, you have to reset the
present time only if the display is flashing. The
HARDNESS and RECHARGE TIME never require
resetting unless a change is desired.
Even if the timer is incorrect after a long power
outage, the softener works as it should to keep
you water soft. However, regenerations may occur
at the wrong time of day until you reset the timer
to the correct time of day.
ERROR CODE
An error code could appear in the
face plate display if a problem
occurs in the softener electronics.
If you see an error code instead of
the time of day, please call you
local Sears Service Department
for service.
SOFTENER STATUS DISPLAY
1. SERVICE ( PROVIDING SOFT
WATER) POSITION: The display
shows the present time of day. If
``TURBINE'' is flashing, soft water
is currently in use.
2. RECHARGE POSITIONS:
A. Fill Cycle - FillinG NOW
shows in the display. If soft water
is being used, ``TURBINE''
flashes.
B. BRINING, BACKWASH AND
FAST RINSE CYCLES - The disĆ
play shows the minutes of reĆ
charge remaining before return
to soft water service. RECHARGE
NOW is also flashing.
IF YOU NEED HELP ON THE USE OF THE TIMER FEATURES, CALL TOLL FREE,
NUMBER 1–800–426–9345.
NOW
PM
TURBINE
.
.
NOW
TURBINE
.
.
RECHARGE NOW