Filter
Top Products
SECTION 1 WATERsOrrE.ERSTART-UP
t I
1C. PROG,RAM THE TIMER
F
m
DOWN
UP buaon button
(_\ --"'--"
lmNla=m=_
ON/OFF - HOLD butto_ SELECT butlon
(RECHARGE TONIGHT- NOW)
J
When the transformer is plugged in, the model
code SC21 shows in the face plate display for a
few seconds, followed by a test number (exam-
ple: $4.0). After the test number, 12:00 AM
begins to flash. PRESENT TIME and RE-
CHARGE TONIGHT show at the bottom of the
display.
I I
m_ p4p_ .
• •e el
II_"_ _l"_e" .e •
NOTE:
If SC - - flashes in the display, press the UP
button (FIG. 1) until SC21 does show. Then
press the SELECT button to display the flashing
12:00 AM. IF OTHER THAN SC21 SHOWS
when the transtormer ts pluggeo in, please see
page 1/ to reset.
SOUND =BEEPER': A =beeper" sounds while
pressing buttons for timer set-up. One beep
signals a change in the face plate display.
Repeated beeps means the timer will not accept
a change from the button you have pressed,
telling you to use another button. For example,
while setting the hardness (step 2), the beeper
sounds repeatedly when the display reaches 1
using the DOWN button, or the highest hardness
setting using the UP button.
1. SET PRESENT TIME OF DAY:
NOTE:
ifthe words... PRESENT TiME donotshowin
the display, press the SELECT button (FIG.
1) until they do.
• Press the [;_IUP/DOWN _]buttons to set the
present time. Press UP to move the display
ahead; press DOWN to move the time backward.
,=e tmei,
noon and midnight, be sure PM
shows.
w,
If the present time is between l= =,_,p"
midnight and noon, be sure AM t_s=_ _,=
shows.
NOTE:
Each press of the UP/DOWN buttons changes
the time by 1 minute. Holding the buttons in
changes the time 32 minutes each second.
6