Filter
Top Products
OTHER THINGS TO KNOW
SECTION 4
19
4A. HOW TO “FINE-TUNE” YOUR SOFTENER
c. Press the RECHARGE DAY button ¢ and
SUnday begins to flash.
---- If you want regenerations on Sunday (from
regeneration table), press the SET/CLEAR but-
ton £ to display ON.
---- If you donot want Sunday regenerations,press
SET/CLEAR button £ to display OFF.
d. Press the RECHARGE DAY button ¢ again
to display aflashing MOndayand ON(facto-
ry set recharge). As you did in step c, use the
SET/CLEAR button £to change the display
from ON to OFF, or from OFF to ON.
e. Press RECHARGE DAY button ¢ to display
a flashing TUesday, WEdnesday, etc., each
time using the SET/CLEAR button £ to dis-
play either ON or OFF as needed.
After recharge is either set or cancelled for
SAturday, press the PRESENT TIME AND
DAY button ¡ once again to return the pres-
ent time and day display.
2. SET THE FILL CYCLE MINUTES
a. Press and hold the RECHARGE TIME button
© until FILL shows in the display, then re-
lease button ©. After a few seconds, the fill
cycle minutes (factory setting¼8) will flash.
b. Press the SET/CLEAR button £ to set the
minutes of fill cycle needed, as shown in the
regeneration table.
NOTE:
You may get hard water between regenerations
if youset thetimer forfewer fillminutes thanthe
Regeneration Table shows you to set. A higher
setting than needed will waste salt.
NOTE:
Press SET/CLEAR and quickly release to move
the display ahead 1 minute at a time. Or, hold the
SET/CLEAR button to move the display ahead 2
minutes each second. THE DISPLAY BEGINS
OVER AT 0 AFTER PASSING 59.
c. Press PRESENT TIME AND DAY button ¡
to return the present time and day display.
TO SET THE PRESENT TIME OF DAY, AND
DAY OF WEEK, SEE PAGE 6.
IF YOU NEED HELP TO PROGRAM THE TIMER, CALL TOLL FREE,
NUMBER 1-800- 426-9345.