Filter
Top Products
INSTALLATION REQUIREMENTS
Your air conditioner will install into standard double
hung windows with actual clear opening widths of
22 to 36 inches (558mm to 914mm) (FIG. 1).
Lower sash must open sufficiently to allow a clear
vertical opening of 14 inches (356mm). Side louvers
and the rear of the air conditioner must have clear
air space to allow enough airflow through the
condenser for heat removal. The rear of the unit
must be outdoors, not inside a building or garage.
14" min
Inner sill
Winddow
Offset
Sill
t
Exterior
FIG, I
ELECTRICAL SERVICE
Check your available electrical service. The power
supply available must be the same as that shown on
the unit nameplate (found on left side of cabinet).
All models are equipped with a 3-prong service plug to
provide proper service and safe positive grounding. Do
not change plug in any way. Do not use an adapter
plug. If your present wall outlet does not match your
plug, call a qualified electrician to make the necessary
corrections. SAVE CARTON and this OWNER'S
MANUAL for future reference. The carton is the best
way to store unit during winter or when not in use.
IT:
To avoidrisk of personalinjury,propertydamage, or
)roduct damagedueto theweight of this deviceand
sharp edgesthat may beexposed:
• Air conditionerscovered inthis manualposean
excessiveweight hazard.Two or more peopleare
neededto moveand installthe unit.
To preventinjury or strain,use properlifting and
carryingtechniqueswhen movingunit.
• Carefullyinspectlocationwhere air conditionerwill
be installed.Besure itwill supportthe weightof
theunit overan extendedperiod of time.
• Handleair conditionerwith care.Wear protective
gloveswheneverlifting or carryingthe unit. AVOID
thesharp metalfins offront and rearcoils.
• Make sureair conditionerdoesnot fall during
installation.
INSTALLATION HARDWARE
ITEM NAME OF PARTS Q'TY
A SHORT SCREW 11
B WOOD SCREW 5
C L BRACKET 3
D FOAM STRIP 1
E FOAM SEAL 1
F SIDE CURTAIN 2
G DRAIN PIPE 1
H SUPPORT BRACKET 1
REQUIRED TOOLS:
• Tight Fitting gloves
• Standard screwdriver
• Phillips screwdriver
• Pliers
• Sharp knife
• 3/8-inch open end
wrench or adjustable
wrench
• 1/4-inch hex socket
and ratcher
• Tape measure
• Electric drill
• 1/4-inch drill bit
-5-