Filter
Top Products
Set Up the Machine
Plug in the Machine and Switch on the Power
SECTION
2. PREPARE THE MACHINE FOR SEWING
• Foot Control Use
NOTE:
1.
2.
3,
Plug
connector
Machine
plug
J
Before inserting the plug into your
machine, be sure the power switch is
OFF.
Check your outlet to be sure it is a 110 to 120
Volt AC outlet.
Insert the machine ptug into the three-prong
plug connector, as shown. It will only fit one
way.
Insert the power supply plug into the outlet.
light
4. Push the light and power switch to turn
on the power and sewing light.
SAFETY FEATURE:
Your machine will not operate unless the
light/power switch is turned on. If you are
interrupted or stop sewing, turn off the
light/power switch to prevent injury to
children, NOTE:
OPERATING INSTRUCTIONS
"For appliances with a polarized plug (one blade wider than the other).
To reduce the risk of electric shock, this plug is intended to fit in a
Foot control
The foot control regulates the speed at
which you saw,
To increase speed, gently press down with
the ball of your foot.
To decrease speed, release your foot pres-
sure slightly.
The foot control is sensitive and
wilt increase'or decrease your
sewing speed immediately.
Practice on a scrap of fabric to
regulate your sewing speed to
polarized outlet only one way. If the plug does not fit fully in the outlet, your taste and needs.
reverse the plug. Ifit still does not fit, contact a qualified electrician to install
the proper outlet. Do not modify the plug in any way."
"Foot Controller Model YC-482P for use with Sewing Machine Models
385.1148xxx, 385.1158xxx, 385.1168xxx, 385.1258xxx, 385.1268xxx,
385.12612x x x, 385.1278x xx, 385.11607x x x, 385.12710× x x, 385.12TI4x x x,
385.12712xxx, 385.17622xxx, 385.11608xxx, 385.12814xxx and 385.12014xx×.
x xx - represents numbers 000 through 999."
(For U.S.A. market only)
100-316-005 5