Filter
Top Products
9
INSERTING OR REPLACING THE BATTERIES
- This remote control uses two AAA batteries.
Remove the back cover of the remote control.
Insert two “AAA” 1.5V batteries, making sure they are in the correct position (see instructions inside
the battery compartment)
Replace the cover.
Do Not Mix Old And New Batteries. Do Not Mix Alkaline, Standard (Carbon - Zinc), or Rechargeable (Nickel -
Cadmium) Batteries.
Dispose of old batteries properly. Do not leave batteries in the remote if it will not be used for longer than
2 months.
SOME IMPORTANT INFORMATION ABOUT USING THE REMOTE:
- The remote control needs to stay
within 5 meters from the receiver
on the appliance. Reception is
confirmed by a beep from the
main unit.
- The remote control will not
operate if curtains, door or other
material block the signal from
the receiver to the remote
control.
- Prevent any liquid from falling
into the remote control. Do not
expose the remote control to
direct sunlight or heat- if the
infrared signal receiver on the
indoor unit is exposed to sunlight,
the air conditioner may not
function properly.
- If other electrical appliances
react to the remote control, move
them out of the way.
- When using the unit in out of
room air conditioning mode point
the remote control to signal box
located in the window kit.
Reception is confirmed by LED
flash from the remote receiver
kit.
- Do not store the remote control
outside of the recommended
temperature range of -5°C60°C
or -41°F/140°F.
REMOTE CONTROL