Filter
Top Products
5
Prior to installing the unit, check for the following:
1. To avoid damage, place the unit in an upright position for at least 12 hours before initial set-up.
2. Release the exhaust hose holder in the unit and take out the exhaust hose.
3. Fasten the exhaust hose before turning the unit on.
4. Expand the exhaust hose, then turn in the direction of the arrow displayed and remove it from the
unit.
5. Expand the exhaust hose, then turn in the direction of the arrow displayed and connect it to the unit.
1. Plug the unit into a 120V~60Hz grounded electrical outlet. DO NOT USE A REGULAR EXTENSION
CORD. If it is necessary to use an extension cord with this unit, use an approved air conditioner
extension cord only.
LOCATION OF THE PORTABLE AIR CONDITIONER (Figure 1)
1. Select a location near a window and electrical outlet.
2. Install the Portable Air Conditioner in a flat, spacious location
where the air outlets will not be covered up. Ensure there is a
minimum clearance of 30cm from the appliance to the wall or
other obstacles such as furniture. The plug should be easily
accessed after the appliance is positioned.
3. If the unit is to be placed outside of the room to be cooled, you
should try to position the unit on a flat solid surface and in an
area protected from rain and sun exposure such as sunroom,
veranda or hallway. You should not operate the unit in moist
areas, such as e.g. saunas or similar areas.
WINDOW KIT INSTALLATION
The Window Kit (included) has been designed to fit most standard vertical and horizontal windows. It may
be necessary to improvise some aspects of the installation procedures for certain types of windows.
Note: If the window opening is less than the mentioned length of the window slider kit, make the Window
Slider Kit shorter by cutting it on the side with a hole to fit the window opening, be careful not to cut off the
hole.
The hose must be attached to the correct side of the unit for the given installation (see operating instructions).
To change the hose to the other side of the unit, gently lift upwards the output vent cover, move hose unit to
the other side then replace the output vent cover on the other side hose was just removed from.
INSTALLATION