Filter
Top Products
If pmenum is wider than stiffener:
2. The five reference hole marks you've made on
the pbnum outline the area that must be cut out.
Mark straight Hinesconnecting the five points.
WARNING: Wear safety giasses! Be sure not to driU
or cut into air conditioner coii or tubing! BfebctMc driU
is used, be sure it is propeMy grounded.
3. DriU or punch a iarge hob in one corner of the
area to be cut out. This wiU aUow you to insert tin
snips or a metai saw.
4. Cut along the lines connecting the five points. If
any of the cut edges are rough, fib them smooth.
5. DriU the remaining hobs marked on the pbnum
with a 1/8" drill bit.
6. Mount the stiffener with the mounting tabs facing
out toward you. Use the seven sheet metal
screws, supplied, to fasten the stiffener. Make
sure the stiffener is flush with the plenum and is
airtight. Seal around the edge with caulking (not
furnished) if necessary.
7. Using the two finger grips (Fig. 9) on the lower
edge of the front panel, simply lift the front panel
about 1/8" straight up, swing the lower edge out,
pull down until the front panel is free. Remove
lower rod screw (Fig. 9).
Disconnect media motor wiring at the electrical
disconnect. Grasp both ends of the electrical
disconnect and simply pull apart (Fig. 9).
WARNING: Do not pull on wires to separate
electrical connector.
Upper Case Electrical Disconnect
Front
Panel
Finger Grips
Lower
Rod
Screw
Reservoir Lower
Assembly Case
Latch
Fig, 9
Remove the reservoir assembly. Remove the
lower case from the humidifier by unfastening
the latches on both sides and removing the
lower rod screw. Set the lower case, reservoir
media wheel assembly, and front panel aside.
Remove the humidistat from the lower case.
8_
Hang the upper case assembly on plenum stiff-
ener mounting tabs (Fig. 7). Tabs may have to
be bent out slightly to fit into the slots in the
back of the upper case assembly. Secure the
upper case to the stiffener by pressing the
capped fastener (No. 47, Page 16) through the
back of the humidifier and into hole "A" (Fig. 10).
NOTE: It is very important that this fastener be
used. If the upper case is not attached with the
fastener, it could be dropped and damaged during
routine maintenance.
Conduit Box Hole "A"
Fig, 10
HUMIDISTAT
Locate the humidistat on the return (cold) air
plenum (Fig. 11). DO NOT install the humidistat
on the supply (hot) air plenum because the
humidistat cannot accurately measure indoor
relative humidity and will cause the humidifier to
function improperly.
Cut
Hole
Return
Air
Plenum
Gasket
Supply
Air
Plenum
\\
Fig, 11
2, The humidistat mounts in a horizontal position,
Using gasket as a template, mark the location
of the two mounting holes and the opening for
the humidistat on the return air plenum,
3. Drill 1/8" holes for two mounting screws.
Cut out the opening for the humidistat.