Filter
Top Products
18
Program The Timer
Large Capacity
Display
DOWN Button
UP Button
REGENERATION Button
SELECT Button
Model 38306
Model 39306
PROGRAM THE TIMER
1. When the transformer is plugged in, a model code and a
test number (example: J1.1) show in the face plate. This
will display for four (4) seconds. Then, 12:00 PM and
the words SET TIME begin to flash.
NOTE: If “- - - -” shows in the display, press the UP or
DOWN button until either S 25, for model 38306, or
S 26, for model 39306, shows in the display. Then,
press the SELECT button to set, and change to the
flashing SET TIME display.
2. To check the model code, unplug the transformer at the
wall outlet and plug in again. If other than S 25 or S 26
shows, refer to the Troubleshooting Section.
SOUND “BEEPER”: A “beeper” sounds while pressing
buttons for timer setup. One beep signals a change in the
face plate display. Repeated beeps mean the timer will not
accept a change from the button you have pressed, telling
you to use another button. For example, while setting the
hardness, the beeper sounds repeatedly when the display
reaches 1 using the DOWN button, or the highest hard-
ness setting using the UP button.
SET PRESENT TIME OF DAY
If the words SET TIME do not show in the display, press the
SELECT button until they do show in the display. Press the
UP or DOWN buttons to set the present time. Press UP to
move the display ahead; press DOWN to move the time
backward. If the present time is between noon and midnight,
be sure PM shows. If the present time is between midnight
and noon, be sure AM shows. Each press of the UP or
DOWN buttons changes the time by one (1) minute. Holding
the buttons in changes the time 32 minutes each second.
FIG. 25
FIG. 26
FIG. 24
Questions? Call The Kenmore Water Line 1-800-426-9345