Filter
Top Products
0
INSTALLING MACHINE HEAD IN PORTABLE
AND CABINET
Loosen the two hinge screws under holes in the rear
edge of the machine bed (1) Raise hinge pins in the
cabinet cutout (2), Slip machine head onto the pins
and tighten hinge screws securely (3),.
Lower machine head to front flap+
Screw spoor pins in place+ Lay the plastic discs over
the spool pins D_scs and pins are packed in the
accessory box
SEWING LIGHT
The sewing tight is located inside the face cover plate
as shown, tt may be turned on or off by pushing the
light switch In order to operate the machine the
switch must be on.
To remove bulb, turn light switch off, open the face
cover plate by swinging it open, push bulb in slightly,
turn bulb clockwise, and remove from socket+ To
repEace push in new bulb and turn counter clockwise,+
See illustration 4,
CONNECTING MACHINE
Push the plug onto three-prong connector under the
bed plate+ Plug machine cord into any 110-120V wall
outlet° See illustration 5
,d