Filter
Top Products
CHANGING THE PRESSER FOOT
The various attachment feet available for certain kinds of work are to be
fastened to the presser bar
To attach the foot, raise the presser bar to its highest position by raising
the presser foot lever Loosen the presser foot thumb screw, choose the
proper foot, insert from the front Tighten the screw using the large screw
driver and make sure that the foot is secure
TURNING A CORNER
Stop sewing machine with needle in fabric, Raise presser foot Turn fabric
Lower presser foot and continue stitching
FASTENING A SEAM
Be sure both threads are drawn back under the presser foot Lower needle
into fabric about ½ inch from beginning of seam Push stitch length
control lever up for reverse stitching Stitch in reverse until needle reaches
beginning of seam
Move stitch length control lever _lown for forward stitching and complete
seam When you reach the end, raise the stitch length control lever and
sew back over _ inch of completed seam
Models 151, t52, 1649 Model 150
FEED DOG CONTROL
The feed dog controi ]<nob is situated on the right front of
machine bedplateo When knob is turned to the other side
of "U" mark, feed dog drops and does not pull material
This allows the operator freedom of movement of material,
as for darning, For regular sewing, turn knob to the "U"
mark (Feed dog up)
15