Filter
Top Products
DARNDNG
WITH
1
2
PRESSER FOOT:
Turn feed dog control to left,
Press down outer ring of presser foot knob, see page 10 With presser foot konb in this
position, mending, darning, monogram work, ete, may be done.
3 Stretch fabric tightly between two spring embroidery hoops and place under needle
4 Lower presser bar so thread will have some tension° When you start to darn, move fabric
back and forth to cover darning area., Then turn fabric and continue sewing at right angles
to the previous stitching. Use medium machine speed You can make any length stitches
desired, Slow movement of fabric wilt make short darning stitches, Fast movement will
make long stitches
5 When you finish darning, raise presser foot and remove fabric Increase pressure for
general sewing by pressing down inner pin of the presser foot knob Turn feed dog control
to right
18
WITHOUT PRESSER FOOT:
1, Turn feed dog control to left
2 Remove presser foot.
Proceed as directed under steps 3 and 4 above.
3o When you finish darning, raise the presser foot lever and remove fabric, Replace presser
foot, and increase pressure for general sewing, Turn feed dog control to right