Filter
Top Products
BELT ROUTING
Correct Routing of Belt
(Selector in Carpet Position)
Assembly
Carpet/Bare Floor Shaft
Selector Shaft
Incorrect Routing of Belt
(Belt on Selector Shaft)
--t)2( , ,, Carpet/Bare
Brush .,.7 Motor
Assembly Carpet/Bare Floor Shaft
Selector Shaft
Incorrect Routing of Belt
(Selector in Bare Floor Position)
"_ Carpet/Bare
/ •
/ \" {Q FloorPedal
Assembly Belt Carpet/Bare Floor
Selector Shaft
Press firmly, checking to see that each
end is completely inserted.
Belt
\
Agitator_
Assembly
Check to see that the belt is centered in
the belt groove. "PJrn the brush assembly
with your fingers to see that it turns freely,.
To re-attach .the base plate, insert the
tabs into the slots along the front edge of
the base. Place the vacuum in full upright
position° Lower the base plate to its origi-
nal position°
Full Upright Position
Tab Locations
As the base is lowered the inner areas
will brush against the dust compartment
wheels. A gentle pull outward may assist
in reassembly.
Two Locking Tabs Press the
base plate
down until
the two
locking tabs
snap into
place,
Re-install the
two screws
that secure
the base
plate,
Screws
Return the cleaner to the upright position
before plugging into the electrical outlet.
18