Filter
Top Products
1, Unplug cord from wall outleL DO NOT
drip water on cleaner.
2, Clean exterior using a clean, soft cloth
that has been dipped in a solution of mild
liquid detergent and water, then wrung dry,
Wipe dry after cleaning.
3oTo reduce static electricity and dust build-
up, wipe outer surface of cleaner and
attachments.
Check motor safety filter occasionally and
E
........ "' # N
CAUTIO
Do not use attachments if they are
wet. Attachments used in dirty
areas, such as under a refrigerator,
should not be used on other
surfaces until they are washed,They
could leave marks.
I I 11111, _1 ii1,111,1=,,i,1,,i' , i
change when dirty.
!.13 ......
Electrical Shock Hazard
Unplug power cord from electrical
outlet. Do not operate the cleaner
without the motor safety filter. Be
sure the filter is dry and properly
installed to prevent motor failure
and/or electrical shock.
Remove the bag as outlined in the BAG
CHANGING section°
MOTOR SAFETY FILTER
ELECTROSTATIC
This white and grey filter must be replaced
when dirty It should be replaced regularly
depending on use conditions, The filter
CANNOT be washed as it will lose its
dust trapping ability.
NOTE: Use motor safety filter #20-86883,,
In Canada, #20-86883C.
1. Lift the rubber
retainer and pull
out motor safety
filter as shown.
fA\" f
i/M,,
!
2. Replace the fil-
ter, white side out,
by sliding it back
into place under
the ribs in the bag
cavity. Tuck filter in
so that it fits com-
pletely under the
rubber retainer,
3. Replace the bag as outlined in the BAG
CHANGING section.
,i CAUTION
NEVER REUSE A DUST BAG. Very
fine materials, such as carpet fresh-
ener, face powder, fine dust, plaster,
soot, new carpet lint, etc. can clog
the bag and cause it to burst before
it is full and may cause damage to
vacuum motor, Change bag more
often when vacuuming these materi-
als.
16