Filter
Top Products
5
Important Safeguards For All
Electrical Appliances
• Carefully read all instructions before operating
the appliance and save for future reference.
• Remove and safely discard all packaging
material and promotional labels before using
the appliance for the first time.
• Fully unwind the power cord before use.
• Do not let the power cord hang over the edge
of a bench or table, touch hot surfaces or
become knotted.
• To protect against electric shock, do not
immerse the power cord, power plug or
appliance in water or any other liquid, unless it
is recommended in the cleaning instructions.
• The appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or lack
of experience and knowledge, unless they
have been given supervision or instruction
concerning use of the appliance, by a person
responsible for their safety.
• Children should be supervised to ensure that
they do not play with the appliance.
• It is recommended to inspect the appliance
regularly. Do not use the appliance if the
power supply cord, plug, connector or
appliance becomes damaged in anyway.
Return the entire appliance to the nearest
authorised Kambrook Service Centre for
examination and/or repair.
• Any maintenance other than cleaning should
be performed at an authorised Kambrook
Service Centre.
• This appliance is for household use only. Do not
use this appliance for other than its intended
use. Do not use in moving vehicles or boats.
Do not use outdoors. Misuse may cause injury.
• The installation of a residual current device
(safety switch) is recommended to provide
additional safety protection when using
electrical appliances. It is advisable that a
safety switch with a rated residual operating
current not exceeding 30mA be installed in
the electrical circuit supplying the appliance.
See your electrician for professional advice
• Always turn the appliance to the OFF
position, switch off at the power outlet
and unplug at the power outlet when the
appliance is not in use.
• Before cleaning, always turn the appliance to
the OFF position, switch off at the power outlet,
unplug at the power outlet and remove the
power cord, if detachable, from the appliance
and allow all parts to cool.
• Do not place this appliance on or near a heat
source, such as hot plate, oven or heaters.
• Position the appliance at a minimum
distance of 20cm away from walls, curtains
and other heat or steam sensitive materials
and provide adequate space above and on
all sides for air circulation.
• Do not allow materials that have been in
contact with oil, petroleum based products
or drying fluids to come in contact with the
heater.
• Do not run the cord under carpeting or cover
the cord with rugs, runners or the like. Arrange
the cord away from traffic areas and where it
will not be tripped over.
• To disconnect the heater, switch control to off,
turn off at the power outlet then remove the
plug from the outlet.
• Do not insert or allow foreign objects to pass
through the inlet or outlet openings. This may
cause an electric shock, fire or damage the
heater.
• Do not touch hot surfaces.
• Switch off at the control switch and power
outlet, then unplug and allow the heater to
cool down before cleaning or storing.
• Use this heater only as described in this
instruction manual. Any other use not
recommended by the manufacturer may
cause fire electric shock or injury and voids all
warranties.
• Keep combustible materials such as drapes
and other furnishings at least 2.0 metres from
the front and 0.5m from the sides and rear
(when it is intended for floor use) and 1.0m
from the top of the heater.
• To prevent a possible fire or heat damage,
allow ample space around the heater (at
least 2.0m at front, 1.0m at the top and 0.5m at
the rear and sides when it is intended for floor
use), (at least 2.0m at the front, 1.0m at the top
and 0.5m at the sides when it is wall mounted)
and do not totally or partially block the air inlet
or outlets in any manner. Check the openings
from time to time for accumulated dust.
KMH100_IB_A11_FA.indd 5 14/09/11 1:58 PM