Filter
Top Products
10
2. As a general safety guide select
a suitable location to wall mount
the heater, approximately 0.5m
from any furniture/furnishing either
side of the unit and 2m from any
furniture/furnishing placed in front
of the heater. The heater must be
mounted horizontally as per Fig 8.
Fig. 8
3. When selecting a location, make
sure the base of the heater is at
least 0.5m from the floor and at
least 1.0m from the ceiling.
4. Measure out and mark the screw
locations. Once you are confident
that the screw locations are
correct, drill suitable size holes.
5. Take care with inserting the screws
into the holes you have made,
and then mount the heater onto
the wall bracket.
Using Your Micathermic Heater continued
6. Once the heater is mounted
on the wall, lodge the heater
to the mounting bracket to
prevent the heater from being
accidently dislodged from the
mounting bracket.
7. Visually inspect the front panel
to ensure no foreign material is
blocking this area.
CAUTION: Do not
mount the heater below
curtains and/or other
flammable items.
Turning Your Heater On
Turn the heat setting dial to the OFF
position. Make sure that the switch on
the THERMOSTAT dial is set to MIN.
Plug the cord into a 230V or 240V
power point and switch on.
NOTE: To avoid an electrical
circuit overload, it is
recommended that no other
appliances are plugged into
the same circuit as your heater,
when it is in use.
KMH100_IB_A11_FA.indd 10 14/09/11 1:58 PM