Filter
Top Products
– 12 –
English
Creating Your Own Sound Mode—User Mode
You can change SEA (Sound Effect Amplifier) pattern to suit
your preference. The SEA (Sound Effect Amplifier) pattern can
be adjusted into 5 frequency ranges—LOW1, LOW2, MID,
HIGH1, and HIGH2. These changed settings can be stored in
the USER 1, USER 2, and USER 3 modes.
• There is a time limit in doing the following steps. If the setting
is canceled before you finish, start from step
1
again.
On the unit ONLY:
1
Select one of the preset sound modes.
• If you want to add the surround elements in your SEA
(Sound Effect Amplifier) pattern, select one of the
surround modes (DANCE, HALL, or STADIUM) before
starting the procedure below. (See “Selecting the Sound
Modes” on page 11.)
2
Press SET/DISPLAY while the
selected sound mode is still shown
on the display.
3
Adjust the SEA (Sound Effect
Amplifier) pattern.
1) Turn 4 / ¢ to select the
frequency range (LOW1, LOW2,
MID, HIGH1, or HIGH2).
2) Press 1 or ¡ to adjust the
level (–3 to +3) of the selected
frequency range.
3) Repeat steps 1) and 2) to adjust
the level of the other frequency
ranges.
4
Press SET/DISPLAY again.
V
C
D
N
U
M
B
E
R
P
R
E
S
E
T
SET /
DISPLAY
Current level appears.
5
Turn 4 / ¢ to select one
of the user modes (USER 1,
USER 2, or USER 3) in which
you want to store your SEA
(Sound Effect Amplifier)
pattern.
6
Press SET/DISPLAY again.
The SEA (Sound Effect Amplifier) pattern you have
created are stored into the user mode selected in step
5
.
To use your own sound mode
Select USER 1, USER 2, or USER 3 mode when using the
sound modes. See “Selecting the Sound Modes” on page 11.
When you unplug the AC power cord or if a power
failure occurs
The setting will be erased in a few days. If this happens, set the user
modes again.
Setting the AM Tuner Interval Spacing
Some countries space AM stations 9 kHz apart, and some
countries use 10 kHz spacing.
On the unit ONLY:
You can only change the AM tuner interval spacing while
tuning in to an AM station. (See page 13.)
Press while holding down 7.
• Each time you press these buttons, the AM tuner interval
spacing alternates between 9 kHz and 10 kHz.
Setting the display brightness
You can set the display brightness to either bright or dim by
pressing and holding 7 button for more than 2 seconds. You
might find this convenient when you are enjoying movies or
music in a darkly lit room.
Each time you press the button, the displays alternates
between bright and dim.
SET /
DISPLAY
V
C
D
N
U
M
B
E
R
P
R
E
S
E
T
SET /
DISPLAY
EN09-13.CA-HXZ7/9V[US,UN,UX]/1 22/1/03, 4:44 PM12