Filter
Top Products
Operation (continued)
6
Setting the Clock
Remote Control Beeping/Silent Modes
Auxiliary Controls
Power Save Mode
The Refresh Personal Hygiene System™ includes a power saving feature to reduce electrical
consumption when not in use. Once set, the Power save function turns the Refresh ON and OFF each
day according to your programmed time settings.
Setting the Power save Start and End Times
a) Press and hold the Power save button for 5 seconds. “POWER SAVE START” on the
Remote and the Power save LED on the Refresh will flash.
b) Adjust the Power save Start time using the
WATER FLOW button to set the HOUR
and the
WATER FLOW button to set the MINUTES. When the desired Start time is
displayed on the Remote, press the Power save button again.
c) “POWER SAVE END” on the Remote and the Power save LED on the Refresh will flash.
d) Adjust the Power save End time using the
WATER FLOW button to set the HOUR
and the
WATER FLOW button to set the MINUTES. When the desired End time is
displayed on the Remote, press the Power save button again.
The remote LCD will show “POWER SAVE ON” and the Power save LED on the Refresh will be green. Power
save function is now ON and the unit will go into Power save mode at the programmed start time.
Enabling and Disabling the Power save
a) Press the Power save button to toggle between Power save ON and Power save OFF.
b) To change Power save Start and End Times refer to the procedure above.
When Power save is Operating
a) When the Refresh is in Power save mode, the Power save LED on the seat will glow ORANGE.
b) Sitting on the Refresh while it is in Power save mode returns the unit to normal operation. The Refresh will
not re-enter the Power save mode until the next day’s scheduled start time.
a) Press and hold the STOP button on the remote Control for over 5 seconds until the Clock flashes.
b) Use the
button to set the HOUR and the button to set the MINUTES.
There are two (2) buttons on the rear, right corner of the
Refresh for use when the Remote Control is unavailable.
Rear Wash: Sit on the seat and press the AUX WASH button
to begin water flow (only posterior cleaning is available when using Auxiliary Controls).
(For each of the operations below you must start in the Rear Wash mode.)
Water Pressure: Press the AUX WASH button again until the desired water pressure is achieved. Press the AUX
STOP button to discontinue the water flow.
Warm Air Dryer: Press the AUX STOP button to activate Warm Air Dryer. It will automatically be set to the
medium temperature level. Press the AUX STOP button again to turn OFF the dryer.
Seat Temperature: To adjust the Seat Temperature, press and hold the AUX STOP button for more than 5
seconds. Press the AUX STOP button again to change seat temperature: low>medium>high>off.
Water Temperature: To adjust the Water Temperature, press and hold the AUX WASH button for more than 5
seconds. Press the AUX WASH button again to change water temperature: low>medium>high>off.
AUXILIARY CONTROLS
(backup for Remote)
AUX Stop
AUX Wash
The remote control has two (2) operational modes: Beeping Mode and Silent Mode. Beeping mode
beeps to confirm when a command from the remote has successfully been received by the seat.
To change modes, press and hold the WATER TEMP button on the remote for 5 seconds.
EX93000 Refresh Installation Manual 10/06
power
power save
seat heat
seat sensor