Filter
Top Products
Scalding Hazard: Do not allow
water to boil. May result in
severe burns.
■■
Only use mild cleaners to clean the
dispenser’s faucet and plastic components.
■■
Cleaners with acids, alkaline, and organic
solvents will result in deterioration of the
plastic components and void the warranty.
CLEANING THE FAUCET AND TANK
Factory temperature pre-set is 200˚F.
To reset the thermostat to 200°,
turn the indicator one notch to the
right of vertical. After adjusting,
depress or twist the dispenser handle
for 20 seconds for water to re-heat to
the new setting.
■■
To adjust water temperature, turn thermostat
dial on the front of the tank clockwise to
increase temperature or turn counter clockwise
to decrease temperature. Repeat if necessary.
All changes should be minimal.
■■
Regularly inspect the unit for any signs of
leakage. If there are signs of water damage,
immediately remove the unit from service.
■■
To avoid water damage from leakage,
replace all cut, loose or split tubing.
■■
A drain pan, plumbed to an appropriate
drain or outfitted with a leak detector,
should be used in those applications where
any leakage could cause property damage.
PROPERTY DAMAGE
Anytime the instant hot water dispenser is not used
for extended periods of time, unplug and drain unit.
If it is below freezing you will need to unplug the
unit and drain it.
SEASONAL STORAGE/DRAINAGE
■■
Disconnect power from unit.
■■
Push hot water dispenser faucet lever and
allow water to flow until it is cool.
■■
Shut the dispenser off at the valve.
■■
Remove drain screw located on bottom
center of dispenser tank and drain the
water into empty pail.
■■
Empty the tank and then reinstall drain
screw onto the bottom of tank, turning
until snug. Do NOT over tighten.
■■
To place back in order, fill tank with water
and re-connect the electrical plug.
CARE AND USE
Electric Shock Hazard: To prevent electrical shock, disconnect power before
servicing unit. Use only a properly grounded and polarized electric outlet.
approx. 200°
ADJUSTING THE THERMOSTAT
1-year warranty on dispenser & tank
Covers all replacement parts and labor to correct defects in material or workmanship in the dispenser system for the full warranty
period from the date of installation. The warranty includes parts and labor, provided the service is performed by an In-Sink-Erator
®
Factory Authorized Service Center. If the dispenser is replaced rather than repaired, the warranty on the new unit shall be for the
duration of the remaining portion of the original dispenser’s warranty.
Note: Warranty is determined by unit serial number and/or
date of installation. Purchase or installation receipt may be required to verify warranty status. When service is required, and for the
location of your nearest factory authorized service center, call toll free 1-800-845-8345
.
The foregoing warranty does not apply to damage or inoperation resulting from accident, alteration, misuse, abuse,
improper installation, installation not in accordance with these instructions or local electrical and/or plumbing codes. We do not
assume any responsibility for consequential damage. Install using genuine In-Sink-Erator manufactured components only. Use of
non In-Sink-Erator components will void the warranty.
Some states do not allow limitations on how long an implied warranty lasts, or the exclusion or limitations of incidental or
consequential damages, so the above limitations or exclusion may not apply to you. This warranty gives you specific legal rights,
and you may also have other rights which vary from state to state.
WARRANTY INFORMATION
8