Filter
Top Products
For Technical Assistance
1-800-845-8345
For Technical Assistance
1-800-845-8345
3
OVERVIEW OF A
COMPLETED SETUP
■■ Turn off water supply.
■■ If using the sink sprayer hose hole,
remove nut that connects sprayer
hose at bottom of faucet.
■■ Using adjustable wrench, remove nut
connecting sprayer washer flange in
sprayer hole.
■■ Plug hose opening with either a 1/8"
plug or a 1/4" cap (not supplied).
B
If you have to drill through sink or
countertop, you may need to rent or purchase
the appropriate tools.
PREPARATION
START HERE
PROPER INSTALLATION SHOULD TAKE ABOUT 2-4 HOURS
■■
Identify locations for the dispenser
faucet, tank and filter (if applicable).
■■ Check to make sure there is proper
clearance (see chart at left) for
dispenser handles to be fully opened.
■■ Check to make sure counter is not
too thick (see chart at left).
■■ Make sure there is a grounded
electrical outlet within 30" of the tank.
1
A
The wall outlet for your dispenser must have power
supplied to it continuously and must be fused.
It should not be controlled by the same wall switch
that operates your disposer.
C1300 .............. 4
3
⁄8" ..........................3"
H778 ................ 2" ............................3"
Note: Hole size requirement is 1
1
⁄
4
"
– 1
1
⁄
2
"
Required minimum from
center of hole to wall
Maximum counter
thickness (depth)
Electric Shock Hazard: Using an ungrounded or improperly connected
appliance can result in serious injury or death from electrical shock.
This appliance must be grounded. This instant hot water dispenser is equipped with a cord that has
a grounding conductor and a grounding pin. The plug must be connected to an appropriate outlet that
is properly installed and grounded in accordance with all local codes and ordinances.
Do not modify the plug provided with the appliance.