Filter
Top Products
For Technical Assistance
1-800-845-8345
5
Property Damage: Do not pinch or break copper
tubing. Do not distort the last 1 inch of tubing.
Make sure to use fiber gasket
to ensure proper seal.
■■
Unpack dispenser components.
■■
On a firm, flat surface, carefully
straighten the copper tubing.
■■ Ensure that the fiber gasket is
properly seated against the base of
the dispenser head.
2
B
A
Fiber
Gasket
H778
H778
■■ From below the sink, place semi-
circular metal mounting washer over
the mounting screw, ensuring the
mounting washer extends beyond
the sink hole.
■■ Slide washer over so that the screw
is now inside the smaller hole.
Tighten the screw until snug.
■■ Feed tubes down the hole in the sink
or countertop until the base is at rest
on the sink or countertop surface.
■■ Position faucet head at the desired
angle.
Half moon shaped metal washer
should cradle all descending tubes.
An assistant may be needed to hold
the dispenser head in place
while securing the dispenser.
C
D
H778
H778
DO NOT remove mounting screw or
fiber gasket from base of dispenser.
INSTALLING THE FAUCET - H778