Filter
Top Products
14
ESPRESSO FINISH CLOSED CABINET TV STAND
www.insigniaproducts.com
Step 10
:
Attaching the base blocks and skirts
1 Fasten the base blocks (S and T) to the long brace (P) with eight silver1-1/8” flat head screws (GG).
Note: There are no pre-drilled holes in the base blocks. The screws will tighten into the grooves in the base blocks. The
outer base blocks (T) have only one notch and the inner base blocks (S) have two notches. Pay close attention to
the positioning of the base blocks.
2 Fasten the large metal bracket (X) to the bottom (F) with a black 9/16” large head screw (II).
3 Insert the skirts (L and M) into the notches in the base blocks.
Note: Make sure that the long skirt (L) is positioned in front of the large metal bracket.
P
F
X
T
S
S
T
M
M
L
Notch should be
located here
F
i
n
i
s
h
e
d
Notch should be
located here
F
i
n
i
s
h
e
d
F
i
n
i
s
h
e
d
You’ll need:
Phillips screwdriver
II (18)
GG (8)
X (1)
NS-WD1450_NS-WD1450-C_14-0647_MAN_V3_ENG.fm Page 14 Tuesday, June 24, 2014 12:19 PM