Filter
Top Products
Page 10
10.2 Force Operator ID by key code
If selected, a password (key code number) entry screen is opened after power up. The
operator is now required to enter his personal key code. If nothing or an invalid key code
is entered, data printout is not possible. A corresponding message must be confirmed
before operation is allowed.
Key codes can be assigned for 6 different operators, please refer to "Changing
Passwords" section 10.4.
10.3 Access codes
10.4 CHANGING PASSWORDS
Use one of the eight buttons to select the password you wish to change, then enter the
password as usual. The password can be up to 5 digits.
ATTENTION: Be careful when changing the Supervisor Level password. Should you by
mistake enter an incorrect password, you are in trouble!
10.5 Terminate and lock Supervisor level
Press this to return to main display.
10.6 Open tech level
Enter 000 (or new code) then keypad press