Filter
Top Products
A-20
MDriveAC Plus Microstepping Hardware - Revision R031808
Relevant to Firmware Version 3.0.02
Figure C10: Typical Setup, Adapter and Single-End Cordset
12
3
9
1
2
4
5
6
7
8
10
11
15
18
19
13
14
17
16
MDrivePlus
To Customer PC
USB Port
To Controller
Interface
MD-CS100/101-000
Single-End Cordset
MD-CC300-000
Parameter Setup Cable
USB Cable
Length 6.0 ft (1.8 m)
P1
1
TM
P2
Pin 1
Pin 1
MISO
SCLK
MOSI
GND
CS
+5VDC
!
For protyping, all three of these components
(or their equivalent) are required!
MD-ADP-M23
Adapter
Figure C.11: MD-ADP-M23
B100283 REV -
TM
1
0.58
(14.7)
1.59
(40.4)
1.83
(46.5)
0.15
(3.8)
0.84
(21.3)
1.00
(25.4)
Overall Height = .60" (15.2)
Figure C.12: MD-ADP-M23 Mechanical
Specifications
Adapter
The MD-ADP-M23 Adapter provides connection capability between the MD-CC300-000 Parameter Setup
Cable and the 19-Pin M23 connector on the MDriveAC Plus via a single-end cordset. The MD-ADP-M23
has two connectors: a 10-pin IDC, into which the MD-CC300-000 plugs directly, and a 7-Pin Pluggable
Terminal Strip into which the Cordset is connected.