Filter
Top Products
4-6 108548_0711
may be necessary to make more than one pass to properly cut
a lawn.
1. Turn the mower off and shutoff the fuel cock. Discon-
nect the spark plug wire. Turn the mower on its side.
Fuel tank side must be facing up.
2. Remove the normal cutting blade and replace with
mulching blades . Use the bolts supplied with the
mulching blades. The regular bolts will be too short.
Torque blades to 26 - 33 ft.-lb. (35-45 Nm). Fig. 4-13
3. Lift guard and place the spacer in the discharge
chute. Install and bolt the two clips and
together as shown. Fig. 4-14
4. Insert the plug and allow the guard to return to the
normal operating position. Fig. 4-15 and Fig. 4-16
Fig. 4-13
Fig. 4-14
Torque blade bolt to
26–33 ft.-lbs.
(35 –45 Nm)
8
1
3
2
7
7
4
5
9
Fig. 4-15
Fig. 4-16
6
6
Guard