Filter
Top Products
4-4 108548_0711
WARNING: Mower blades are sharp and can cut.
Wrap the blade(s) or wear gloves and use extra caution
when servicing them.
1. Attach the lower handle to the mower with flanged
nuts. Fig. 4-2
2. Assemble the upper handle to the lower handle .
Use the holder on the right hand side and the two
bolts on the left hand side and the flanged cap nuts
.Fig. 4-3 and Fig. 4-4
3. Remove the lower bolt and attach the bar to the
mower as shown. Fig. 4-5. Start the bolt in the hole
but do not tighten. Install the bracketto the lower
handle and attach the bar using hardware and
(flanged cap nutnot shown). Tighten all of the hard-
ware. Fig. 4-5 and Fig. 4-6
NOTE: When adjusting the height of the handle, loosen the
bolt on the bar , before loosening the handle height adjust-
ment bolt. Fix the cable harness to the handle with velcro
straps so that they do not interfere with the opening / closing
of the guard or operation of the machine. The cable harness
should be routed under the lower handle. Fig. 4-7 and
Fig. 4-8
Fig. 4-2
Fig. 4-3
Fig. 4-4
6
3
13
3
7
13
Upper handle
9
7
3
Upper handle
Fig. 4-5
Fig. 4-6
Fig. 4-7
11
11
11
Lower bolt
11
8
10
Lower handle
11
Loosen bolts to
adjust height