Filter
Top Products
13
INSERTING THE BOBBIN
When inserting or removing the bobbin, the needle must be
fully raised.
- Open the hinged cover. (1)
- Hold the bobbin case with one hand. Insert the bobbin so
that the bobbin runs in a clockwise direction (arrow). (2)
- Pull the thread through the slot, down and to the left until
it enters the delivery eyelet (rectangular opening) under
the tension spring. (3)
- Hold the bobbin case by the hinged latch. (4)
- Insert the bobbin case fully into the shuttle race and
release the latch. Make sure that the metal fi nger fi ts into
the notch at the top of the race cover. (5) Push on the
bobbin case to be sure it is clicked in completely.
Attention: Turn power switch to “O” before inserting or
removing the bobbin.