Husqvarna C10 Sewing Machine User Manual


 
61
WARNING FUNCTIONS
Warning animation message display
Buttonhole lever is not lowered
The buttonhole or darning stitch was selected and
the foot control pressed while the buttonhole lever
was raised.
Bobbin winding
The bobbin winder is engaged.
Instruction animation message display
Warning beeping sound
- When operating correctly: 1 beep.
- When the memory is full 30 units of pattern: 2-short beeps.
- When operating incorrectly: 3-short beeps.
- When the sewing machine is thread locked and can’t sew: 8 seconds short beeps.
It means that the thread is twisted or caught and the hand wheel can’t move. Please
look through the Troubleshooting guide to nd the solution. After the problem has been
solved, the machine will continue to sew.
Push bobbin winder stop to sewing
position
If you have not pushed back the bobbin to
the left when the bobbin is full and press any
button or try to sew, the machine will give a
warning sound of 3 beeps.
Please Note: If the problem is still not solved, please contact your local dealer.
Attention: During the sewing, if the thread is caught or wrapped inside the hook stopping
the needle from moving and you continue pressing the foot control, the security switch will
stop the machine completely. In order to restart the sewing machine, clean out the thread
that is caught then turn OFF the on/off switch and then ON again.