Hunter Fan 27188 Fan User Manual


 
6
41797-01 • 07/06/10 • Hunter Fan Company
Hands
Free
Bracket
Hanger
NOTE: Some fans may have considerable excess lead wire.
For easier canopy installation, cut the excess wire leaving
a minimum of 6 inches remaining. Restrip the fan lead
wires 1/2 inch. Place remaining excess wire into the ceiling
electrical box as needed.
Hunter Hands-Free™ Canopy: Connect wiring
as shown in Figure 7. Place receiver inside mounting
bracket. Extend antenna above the ceiling mounting bracket
(approximately 3–6˝).
Bracket Hanger: Starting with the antenna wire, slide
receiver inside mounting bracket. If a ground wire mounting
screw prevents the receiver from sliding into the bracket,
move ground wire and screw to an unused hole at the top
of the bracket or secure with a canopy mounting screw. The
bracket must remain properly grounded. Connect wiring
as shown in Figure 8. Extend antenna above the receiver
(approximately 5–8˝).
Figure 7
Figure 8
4 • Receiver Installation