3 - 1
8
2 - 1 6
Attach wand and tools
Attach tool or wand to the hose (C).
Attach second wand or tool to wand (D)
by pushing it firmly onto the wand.
Twist wand or tool slightly to tighten or
loosen the connection.
Where to buy
Filter bags may be purchased from your
Authorized Hoover Dealer (Depot),
Leading Retailers, Hoover Factory
Service Centers, or through The Hoover
Company on-line at
www.hoover.com
What to buy
To assure cleaning effectiveness, use
only Genuine HOOVER® Allergen
Filtration Type Y disposable filter
bags.
I
Familiarize yourself with these home
maintenance tasks as proper use and
care of your cleaner will ensure contin-
ued cleaning effectiveness.
®
2 - 1 5
G
H
F
E
Select proper tool
E. Dusting brush may be used for
carved furniture, table tops, books,
lamps, lighting fixtures, venetian blinds,
baseboards, shutters, and registers.
F. Furniture nozzle may be used for
upholstered furniture, draperies, mat-
tresses, clothing, automobile interiors,
and carpeted stairs.
G. Crevice tool may be used in tight
spaces, corners and along edges in
such places as dresser drawers, uphol-
stered furniture, stairs and baseboards.
H. Wands are used to give extra length
to your hose. Use them with any of the
above tools.
I. Powered hand tool may be used for
upholstered furniture, carpeted stairs
and hard to reach places.
3. Maintenance
Filter bag
When to replace
Check filter bag from time to time. It is
recommended that you change the filter
bag when dirt reaches the dotted line. If
more dirt than this accumulates, your
cleaner will not operate effectively.
Note: All new carpet has loose fibers
which can fill the bag quickly while
vacuuming.
If you are using the cleaner on new
carpet, be sure to change the filter
bag often.
CAUTION:Very fine materials, such as
face powder, cornstarch, fireplace
ashes or fireplace soot, may seal the
filter bag and may cause it to burst
even though it is only partially full of
dirt. When cleaner is used to remove
material of this nature, change filter
bag often.
It is imperative that you use only gen-
uine HOOVER filter bags made by The
Hoover Company to assure that your
cleaner operates at peak performance.
HOOVER bags can be identified by
these trademarks —
Removing bag door
To change filter bag, press down at top
of bag door and pull door forward.
Remove door.
D
C
How to clean tools
To clean the hose and powered hand
tool, wipe off dirt with a cloth dampened
in a mild detergent. Rinse with a damp
cloth. Do not submerge the powered
hand tool in water.
Cleaning tools may be washed in warm
water with a detergent. Rinse and air
dry before using.
Changing filter bag
Disconnect cleaner from electrical
outlet.
2 - 1 7
J
Check bag indicator
The indicator (J) will begin to show red as
the filter bag fills with dirt.
T h e r e are three conditions that will cause
the indicator to become completely re d :
1. If the bag is full; change the bag.
2. If very fine materials have been picked
up, clogging the bag pores; change the
bag.
3. If there is a blockage at the front of the
c l e a n e r, in the hose, tools or at the bag
opening; remove the blockage (see
“Clearing blockages” section).