Filter
Top Products
Carpet height
adjustment
The cleaning of carpet and rugs takes
place at the nozzle (A).
When it is necessary to raise and lower
the nozzle for various carpet pile
heights, slide the nozzle control knob (B)
to the desired setting.
2 - 9
Settings
For maximum cleaning performance,
the following carpet height settings are
recommended:
• Lowest setting: for all types of carpet
Note: If the cleaner is difficult to push,
slide knob to the next higher setting.
• Higher settings: for very deep pile
carpet where easier pushing effort is
desired, while maintaining good cleaning
performance.
Handle positions
The handle of your cleaner has three
positions; upright for storage and when
using cleaning tools; operating position
for general operation on carpet and
floors; low for reaching under low furni-
ture. Step on handle release lever to
lower handle.
Carrying cleaner
The cleaner can also be moved by
using the carrying handle.
Transporting cleaner
To move your cleaner from room to
room, put handle in upright position, tilt
cleaner back on rear wheels and push
forward.
6
2 - 5
2 - 3
2 - 7
2 - 6
2 - 4
A
B
Embedded Dirt FINDER
feature
With red and green lights (A), the ‘Dirt
FINDER’ system alerts the user to areas of
carpet that may need more cleaning
attention. It is able to sense when larger
amounts of dirt particles, especially
embedded dirt, are removed.
To let you know that the ‘Dirt FINDER’ fea-
ture is ready, the red light will come on
Handle position
For ease in sliding knob, the handle
should be in the upright position (C).
The nozzle will not move into the
adjusted position until the cleaner
handle is lowered to the operating
position (D).
C
D
A
B
HIGH
BARE
FLOOR
2 - 8
TM
when the cleaner is first turned on. After
a few seconds, the red light will go off
and the green light will come on.
Cleaning may then begin.
The green light will remain on through-
out cleaning except when the detector
senses that a larger amount of dirt is
being picked up; then the red light will
come on.
When the red light is on, you should
take additional cleaning strokes in the
area until it changes to green.
•The red light may seldom come on dur-
ing cleaning. This means that your
cleaner is picking up primarily fine sur-
face dust and lint which the system may
not detect, or that the carpet is generally
clean. To increase the feature’s sensi-
tivity to dirt, set the switch (B) to the
“Hi” position.
•At other times, the red light may stay on
for a considerable amount of time. This
means that the carpet contains a high
level of dirt which is being removed by
the cleaner. To decrease the feature’s
sensitivity to dirt, set the switch to the
“Reg.” (Regular) position.