Filter
Top Products
Extra Reach TM hose
(available at additional cost)
The Extra Reach TM hose provides
easier cleaning of stairs and hard to
reach places, Follow the steps
below for attaching and detaching
the Extra Reach TM hose,
Turn cleaner OFF before discon-
necting and connecting hose.
Remove hose end from dirt duct (A),
Align end of Extra Reach TM hose
with projections (B) over slots on dirt
duct (C), Slide hose into slots and
twist hose to lock it into place,
vJ_;| •
E
Align end of hose with projections
(D) over slots (E) on Extra Reach TM
hose, Slide hose into slots and twist
hose to lock it into place, (To detach
hose, reverse procedure),
Attach wands or tools to the other
end of hose,
NOTE: Hose must be connected to
dirt duct and hose tube after
removing Extra Reach TM hose for
carpet or floor cleaning.
G
Attach wand and tools
Attach tool or wand to the hose (F),
Attach tool to wand (G) by pushing
it firmly onto the wand,
Twist wand or tool slightly to tighten
or loosen the connection,
Stair cleaning
Use the hose and powered hand
tool for stair cleaning, Clean from
bottom to top,
CAUTION: To avoid personal
injury or unnecessary wear to car-
pet, and to prevent the cleaner
from falling, always place it at bot-
tom of stairs.
Familiarize yourself with these home
maintenance tasks as proper use
and care of your cleaner will ensure
continued cleaning effectiveness,
Dirt cup
When to empty
It is recommended that the dirt cup
be emptied before the dirt reaches
the fill line (A), or after every use if
preferred, Place the cleaner in the
upright position before removing the
dirt cup,
Disconnect cleaner from electrical
outlet. Do not use cleaner without
dirt cup or filters in place.
CAUTION: Very fine materials,
such as face powder or corn-
starch, may seal the filter and
cause loss of suction. When using
the cleaner for this type of dust,
empty the cup and clean the fil-
ters often.
How to empty
Press dirt cup release button (B)
and pivot cup out,