Hoover U8315960 Vacuum Cleaner User Manual


 
®®
Stand on one end of rug and move
cleaner toward other end. Before
reaching edge, push down on handle.
This will lift up the nozzle and will pre-
vent the rug from clinging to the cleaner.
Continue to lift up nozzle so that when
you have reached the edge, it is com-
pletely off the rug. Move cleaner back to
start again, lower nozzle, and use only
forward strokes.
21
Cleaning lightweight
flexible rugs
Edge cleaning
Using the tools Select proper tool
Attach tools
Special edge groomers are provid-
ed on both sides of the front of the
cleaner to remove dirt in carpet near
baseboards and furniture.
Guide either side parallel to the edge of
carpet or furniture.
22
Tools allow for cleaning surfaces above
the floor and for reaching hard to clean
areas. The cleaner is ready for tool use
when the handle is in the upright posi-
tion.
Note: When handle is in upright posi-
tion, agitator brush roll is automatically
OFF.
Select the proper tool for the
cleaning task.
A. Dusting brush use for carved furni-
ture, table tops, books, lamps, lighting
fixtures, venetian blinds, baseboards,
shutters, and registers.
B. Furniture nozzle use for upholstered
furniture, draperies, mattresses, clothing,
automobile interiors, and carpeted stairs.
C. Powered pet hair cleaning tool use
for upholstered furniture, carpeted stairs
and hard to reach places.
D. Crevice tool use in tight spaces, cor-
ners and along edges in such places as
dresser drawers, upholstered furniture,
stairs, and baseboards.
E. Soft Touch™ floor brush (some
models) use on hard surface floors.
23
F. Telescoping handle/wand can
be extended by depressing the
button (G) and pulling wand outward.
Release button to lock into position.
Shorten the telescoping handle/wand by
depressing the button and pulling wand
back.
24
All tools attach in the same
manner.
Tools may be attached to the telescop-
ing handle/wand or directly to the
hose (see Fig. 26).
25
Attach tool to wand or hose by
pushing it firmly onto the end of
the wand or hose. Twist tool slightly
to tighten or loosen the connection.
For optimum performance of the pow-
ered pet hair cleaning tool, attach it
directly to the hose.
The hose can be removed from the
handle grip by depressing the button
and pulling away from the wand.
(Fig. 5)
26
D
C
B
A
E
F
G
(Cont’d)
09