Filter
Top Products
Using a Phillips screwdriver,
remove the three screws as
shown and lift off lens.
Pull old bulb straight out of socket.
Remove lens
Replace lens
Push new bulb straight into
socket until locked in place. Do
not twist bulb.
Excessive force is not required.
Reposition lens and secure with the
three screws.
39
Headlight replacement
What to buy
This cleaner uses a T3 1/4 wedge
base bulb, HOOVER part no.
27313107.
Disconnect cleaner from electrical out-
let.
Press on handle release pedal and
lower the nozzle so it is flat. Remove
bag door (Fig. 32).
38
12
Align new filter bag collar (B)
with tray (C). Slide bag collar all
the way into tray. The bag collar open-
ing will be sealed to the dirt tube open-
ing.
Tuck in filter bag inside the bag cavity.
Close bag door.
36
Disconnect cleaner from electrical outlet. Do not use
cleaner without secondary or final filter in place.
The secondary filter, located within the grill (A) in the bottom
of the bag compartment, protects the motor from dirt particles.
If filter becomes dirty, slide grill out and remove filter. Hand
wash filter with mild detergent and cold water. Rinse and let
filter air dry completely before repositioning in grill.
Align grill on tracks and slide in until it snaps into position.
Should you want to replace this filter, ask for HOOVER part
No. 38765031.
37
A
B
C
C
Secondary filter
Headlight