Filter
Top Products
®®
DO NOT USE CLEANER OUTDOORS
OR ON DAMP OR WET SURFACES.
POWER button
The POWER button (A) is located
at the top of the cleaner body.
Plug cord into electrical outlet.
To turn cleaner ON, press button once.
To turn cleaner OFF, press button again.
9
A
B
B
A
Using the cleaner
The Surface Command™ control
dial (some models) is an automat-
ic height adjustment that allows you to
choose a cleaning mode for carpet
height or hard surface floors.
For maximum cleaning performance,
the following carpet height settings are
recommended:
Lowest setting: for all types of carpet,
Note: If the cleaner is difficult to push,
turn dial to the next higher setting.
Higher settings: for very deep pile car-
pet where easier pushing effort is
desired, while maintaining good clean-
ing performance.
HARD FLOOR The agitator brush roll is
OFF; the nozzle is set at LOW.
Surface Command™
control dial (some models)
Surface Selector (some
models)
Automatic agitator
brush roll shut-off
Agitator brush roll control
Cord rewind
10
The agitator brush roll will turn off
when the handle is in the upright,
storage position.
12
Rotate control dial to “Carpet”
settings (A) to turn agitator brush
roll ON for cleaning carpet or rugs.
Rotate control dial to “Hard Floor” (B) to
turn agitator brush roll OFF when clean-
ing hard floors.
13
(Cont’d) →
The Surface Selector (some
models) has three carpet height
settings and a hard floor setting. The
Surface Selector turns to allow you to
choose a cleaning mode for carpet
height or hard surface floors.
For maximum cleaning performance, the
following carpet height settings are rec-
ommended:
Lowest setting: for all types of carpet,
Note: If the cleaner is difficult to push,
turn dial to the next higher setting.
Higher settings: for very deep pile car-
pet where easier pushing effort is
desired, while maintaining good clean-
ing performance.
HARD FLOOR MODE (with agitator
brush roll shut off) the nozzle is set at
LOW.
11
07
A
A
OR
Grasp the end of the plug and
pull to release cord from cord
reel. After desired cord length is reached,
the cord will lock into position.
14
NOTE: THE CLEANER IS SHIPPED
WITH THE CONTROL DIAL IN HARD
FLOOR POSITION. BEFORE YOU
BEGIN TO CLEAN CARPETS, ROTATE
THE CONTROL DIAL FROM HARD
FLOOR TO A CARPET SETTING.