Filter
Top Products
!
Replace agitator and latch it in
posi-
I
tion. (Fig. 4).
Make sure that large belt is in center
of pulley, and free of agitator mount-
ings and latch. Turn agitator by hand
to be sure that belt is in proper posi-
tion. (Fig. 5).
Replace bottom plate. (Fig. 6). Make
sure that clips enter into the recesses
on the cleaner bottom plate. Check
to see that latches are pushed back
and will not be covered by plate. (Fig.
6). Place plate in position and latch
securely. Turn agitator by hand to be
sure that belt is in proper position on
pulley.
1
Brushes
When brushes are worn and bristles do
not touch the edge of a card held across
the nozzle, they should be replaced.
(Fig. 1). Alwa
ys replace both brushes
at the same time to maintain cleaning
effectiveness.
I
/
TO REPLACE BRUSHES
Remove bottom plate, belt and agita-
tor following directions on Page 11.
Turn end plates (Fig. 2) of agitator in
opposite direction.
I
11
6