Filter
Top Products
To turn d.p,,
cleaner on, _ \
push switch \ \
down. To \
turn cleaner
off, pull the|
switch up. ._
HANDLE ADJUSTMENTS
The handle on your cleaner has three positions storage, operating,
and low (for reaching under low furniture). The handle can be
lowered by stepping on pedal at the left rear of cleaner. The handle
stiould always be in storage position when cleaning tools are used.
RUG ADJUSTMENTS
The rug adjustment lever located on the right
rear of the cleaner offers four different positions
for better cleaning on a wide range of carpet. The
four positions are: LOW, NORMAL, HIGH
and SHAG.
To select the desired rug position, tilt the cleaner
forward and adjust the lever until it "clicks"
into the desired position.
For best results the lever is conveniently adjusted
by hand.
Select the LOW setting for cleaning Indoor/Outdoor carpet. Notice that
the nozzle of the cleaner is flush with the carpet. For rugs of normal
pile height, select the NORMAL position. If the cleaner is difficult
to push, move the lever to the HIGH position. Choose the SHAG
position for cleaning very long or shag pile carpet.
Note: When removing loose dirt from hard surface floors, adjust the
cleaner to the NORMAL position. The LOW setting on the cleaner
lowers the nozzle to the carpet for effective cleaning of LOW carpet.
However, be certain to change the rug position when cleaning normal
or shag pile carpet, if the LOW setting is used when cleaning normal
or shag pile carpet, there is an increase in the belt load and pushing effort
is greatly increased.
WARNING: ELECTRIC SHOCK COULD OCCUR
IF USED OUTDOORS OR ON WET SURFACES.