Filter
Top Products
The
assembled
cleaner
will
look
like
this
drawing.
Assemble handle
Attach upper handle
Remove clean solution tank (upper tank)
from deep cleaner.
With cord hook (A) to back of deep cleaner,
push upper handle down onto lower han-
dle. Push
bolts
into holes on
front
of
han-
dle.
If
bolts
will
not
go
through
hole
easi-
ioh$dle
is
not
pushed
completely
-
x
Place nuts in recessed areas on
back
of
handle.
Hold each nut in place while
tightening each bolt securely with a
Phillips screw driver.
Only two nuts are needed on this model.
The extra nut is not required but has
been provided for your convenience.
When handle sections are completely
together, squeeze trigger (B) on upper
handle to snap tripqer rod In place.
Replace clean solution tank (upper
tank) by positioning bottom first. Press
on tank handle to snap top of tank into
place.
Press cord into cord clip on back of
handle. Pull cord tight.
Attach hose clip
Push tab on side of clip into hole on
side of handle.
Pivot clip and push other tab into hole
at back of handle to lock into place.
4