Hoover Steam cleaner Carpet Cleaner User Manual


 
6
3-12
3-13
3-14
3-15
3-16
3-17
Using the shoulder strap
A shoulder strap (A) is included for your
convenience. Press the two sides of the
clip (B) to unlock the shoulder strap.
Place the end of the strap with the clip
through the handle of the steam cleaner
and snap to close.
The shoulder strap may then be looped
around the shoulder. Adjust to desired
length.
To change accessories or to fill tank with
water, press the two sides of the clip to
unlock and pull through the handle of
the steam cleaner.
Attach the handle
The handle can be extended to three
sections. Twist and pull to unlock the
end and middle sections. After exten-
sion, twist slightly to lock in place.
To shorten, reverse the procedure.
Place the end of the handle opposite
the grip (A) with flat side up, into the
opening (B) on the handle of the steam
cleaner body. Push down until it locks in
place and handle is firmly secured.
To remove the handle, press on the but-
ton (C) and pull the handle straight out.
To keep the cord out of the way, coil it
loosely around the handle. Insert the
cord through the slot (D) on the handle
grip to secure.
Using the mop pad
Align the tab (A) on the mop pad with
the slot (B) on the front of the cleaner.
Twist the pad in a clockwise direction to
tighten.
Place the mop pad on the floor or wall
surface to be cleaned. To begin clean-
ing, follow Figs. 3-5 & 3-6.
The sponge, located on the underneath
side of the mop pad, will aid in cleaning
and drying the surface.
3-18
To use as a mop
Installing the telescoping handle allows
the steam cleaner to be used as a mop
for cleaning floors or walls.
NOTE: If using the steamer on waxed
surfaces, test in a hidden area to check
for effects on the wax.
3-19
A
D
B
C
B
A
B
A