Filter
Top Products
* Certain Models Only
** May vary according to model
The following is a list of commonly encountered problems and solutions.
If any of these problems persist contact your local Hoover representative.
t
Check that the dust container
lter and motor are clean.t
t
Cleaning power is weak
Empty dust container.t
Check and clean th
lter and motor.t
Check and clean the Floor Brushest
Check and clean the sensors.t
Check and clean the drive wheels.t
The Remote Control** does not work Check the batteries.t
t
t
charge
t
the Charger Base.
cleaning
Clean the dust container an
lter.t
Check the brushes and drive wheels for dirt and debris.t
cleans intermittantly
Check the cleaning times set.t
Check and clean the sensors.t
t
there is no error code display
Contact your local Hoover representativet
Error Codes
The following codes may appear during use or on start up.
Failure Code Explanation
Er01
See ‘Cleaning the Edge Cleaning Brushh
Er02
Debris trapped in the Floor Brushes. See ‘Cleaning the Floor Brushes’
Er04
Left Drive Wheel motor overloaded. See ‘Cleaning the Drive Wheels’
Er05
Right Drive Wheel motor overloaded. See ‘Cleaning the Drive Wheels’
Er06
Both Drive Wheel motors overloaded. See ‘Cleaning the Drive Wheels’
Er07
Left or Right Drive Wheel not making contact with the ground. See ‘Cleaning the
Drive Wheels’
Er08
Er09
Er10
Er12
Dust container is absent. Replace Dust Container.
Check the battery connection.
ATTENTION: If any of these failures persist. Contact your local Hoover representative. DO NOT tr y to
GB
TROUBLESHOOTING
RoboCom2Manual2011__GB.indd 14 14/07/2011 13.40.17
Debris in the Right Edge Cleaning Brush.
See ‘Cleaning the Edge Cleaning Brushh
Debris in the Left Edge Cleaning Brush.