Filter
Top Products
– 32 –
Scheduling
SchedulingScheduling
Scheduling
About Scheduling
About SchedulingAbout Scheduling
About Scheduling
The system provides one end-user schedule (programmable by master/installer only), which
can control various types of events.
• The schedule causes a defined event to start and stop (when appropriate) at a specified time.
• The schedule can be set to automatically repeat at various intervals.
• The schedule can be set for random starting, if desired.
Creating Schedules
Creating SchedulesCreating Schedules
Creating Schedules
1. + [#] + [6] [4]
(Master Code)
Alpha Displays:
1 DISARMED
READY TO ARM
2. Enter “01” as the 2-digit schedule number.
Press [∗] to continue.
ENTER SCHED NO.
00=QUIT 00
3.
Enter the desired 2
-
digit event number from the
following list.
00 = clear the scheduled event
01 = turn a programmed output on or off
ENTER EVENT
(see Using Device Commands section for a list of output device numbers used
in your system)
02 = set a user access schedule for one or more users
(see Security Codes section for an explanation of access groups)
03 = send a “latch-key” report to a pager if the system is not disarmed by a specified
time; message sent is “777-7777.”
04 = automatically arm the system in STAY mode at a specified time
05 = automatically arm the system in AWAY mode at a specified time
06 = automatically disarm the system at a specified time
07 = Display the word “REMINDER” at a specified time
(if selected, the keypad beeps every 30 seconds beginning when the word
“REMINDER” is first displayed, and alternates with the normal keypad display
about every 4-5 seconds. To stop the beeps and cancel the display once it starts,
simply press any key.
Press [∗] to continue.
4. For event number “01,” enter the output number
associated with this schedule.
Otherwise, this prompt is skipped.
Press [∗] to continue to the “Start” prompt below.
RELAY NUMBER
XX