Honeywell T8611M Heat Pump User Manual


 
21 68-0076—1
Press and hold until the display shows the
time that the temperature should be at the
comfort setting.
Press and hold until the display shows the
desired heating temperature.
If the display flashes while holding down
TEMPERATURE WARMER or
COOLER, the setting limit has been
reached. If thermostat is an auto changeover
model, the heating temperature must be at
least 3 degrees below the air conditioning
temperature. For example, if the cooling
setting is 75° F, the maximum heating set-
ting is 72° F. To set a higher heating tem-
perature, first raise the cooling setting.
Program the MIDDAY time and heat-
ing temperature if desired.
Press and release. The display shows MID-
DAY, but no time or temperature.
Press and hold until the display shows the
time to start the energy saving period.
Press and hold until the display shows the
desired temperature.
NOTE: It is possible to cancel any
period showing on the display ex-
cept MORNING by pushing the
CANCEL PERIOD key. To move
to the next period while program-
ming, simply press the PERIOD
key again.
Program the EVENING time and tem-
perature, if desired.
Press and release. The display shows
EVENING, but no time or temperature.
Press and hold until the display shows the
time the temperature should be at the com-
fort setting.
Press and hold until the display shows the
desired heating temperature.
AHEAD
BACK
WARMER
COOLER
AHEAD
BACK
WARMER
COOLER
PERIOD
AHEAD
BACK
WARMER
COOLER
PERIOD
M2706
AM
MORNING
SET
PT
MON
HEAT
M2705
AM
MORNING
SET
PT
MON
HEAT
M2709
AM
SET
PT
MON
MIDDAY HEAT
M2712
SET
PT
PM
MON
EVENING HEAT
SET
PT
MON
HEAT
EVENING
M2708
AM
SET
PT
MON
MIDDAY HEAT
M2711
SET
PT
PM
MON
EVENING HEAT
T8611M
PROGRAMMING THE THERMOSTAT
SET
PT
MON
HEAT
MIDDAY