Filter
Top Products
– 26 –
86(5)81&7,216
&ORFN&DOHQGDU
Your system can display the current time (see your installer). The date is not displayed, but has an
internal function.
The system must be disarmed.
To set the time and date:
The system will enter the Voice Prompt Calendar Setting mode.
The [#] key can be pressed at
any time to repeat a voice prompt.
NOTES: 1. The keypad beeps twice for invalid data entries (e.g., an hour greater than 12), and the entry will not
be accepted. The keypad beeps once for valid entries.
2. Clock-Setting mode automatically ends if no keys are pressed for one minute.
3. It is not possible to enter the real time clock programming mode from a wireless keypad
4. Pressing any key on a wireless (RF) keypad terminates Clock/Calendar setup.
5. It is not possible to enter the real time clock programming mode when either FC or CA is displayed
on the display.
1. The system will announce, “Enter two-digit hour then press ADD to accept, ESCAPE to quit”.
Hour
(The current hour will be displayed with the AM/PM indication.)
Enter the 2-digit hour (i.e., 01-12).
Press [ADD] to accept the entry and continue to the AM/PM selection.
Press [ESCAPE] to exit Clock/Calendar mode (keypad beeps 4 times).
2. The system will announce, “Enter one for PM, zero for AM, press ADD to accept, ESCAPE to quit”.
AM/PM
(The current AM/PM setting will display A or P.)
Enter 1 for PM or 0 for AM.
Press [ADD] to accept the entry and continue to the minute selection.
Press [ESCAPE] to back up to hour selection.
3. The system will announce, “Enter two-digit minute press ADD to accept, ESCAPE to quit”.
Minute
(The current minute will display.)
Enter the 2-digit minute (i.e., 00-59).
Press [ADD] to accept the entry and continue to the month selection.
Press [ESCAPE] to back up to AM/PM selection.
4. The system will announce, “Enter two-digit month press ADD to accept, ESCAPE to quit”.
Month
(The current month will display.)
Enter the 2-digit month designation (i.e., 01-12).
Press [ADD] to accept the entry and continue to the day selection.
Press [ESCAPE] to back up to Minute selection.